![]() This is the Bentley and I assume the wiring scheme is the same. And then I would just select the lower frequencies from the rear channels, correct (using the built in crossover in my amp)? What about the remote wire? I'm not sure which one that is. Okay, so you're saying I can just tap into the wires? I guess that would make sense. Also the remote turn on is also available in the amplifier harness. Make sure the amp you select has a low pass crossover, so you can control the sub. The outputs of the C33 and CD43 are basically preamp level, so you can solder RCA's to your new wires, and plug them directly into your sub amp. You can tap into those, dont do it after the amp, as it has internal crossovers. ![]() What you need to do is look at the wiring diagram for the stereo, and find the rear channels (or front channels) before they enter the amp, at the amp harness plug. You either have the c33 or the CD43 right? Considering you have HK.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |